Tektronix KEITHLEY 2600B Series, User Manual

Page: 30 / 102

Section 3: Instrument description Series 2600B System SourceMeter® instrument User's Manual
3-14 2600BS-900-01 Rev. A / August 2021
Menu selection Description For more information, see:
SCRIPT Saves and recalls user scripts Series 2600B Reference Manual ,
“Manage scripts”
- LOAD Loads scripts into nonvolatile memory
- SAVE Saves scripts
SETUP Saves and recalls user and factory setup options Series 2600B Reference Manual ,
“
Saved
setups”
- SAVE Saves user setup options
- RECALL Recalls user setup options
- POWERON Sets the configuration used during startup
GPIB Configures the GPIB interface options Series 2600B Reference Manual ,
“
Remote
communications interfaces”
- ADDRESS Configures the address for the GPIB interface
- ENABLE Enables and disables the GPIB interface
LAN
Configures the local area network (LAN) Series 2600B Reference Manual ,
“
LAN
communications”
- STATUS Displays LAN connection status
- CONFIG Configures the LAN IP address and gateway
- APPLY_SETTINGS Applies changes made using the CONFIG menu
- RESET Restores the default settings
- ENABLE Enables and disables the LAN interface
RS232
Controls the options for the RS-232 interface Series 2600B Reference Manual ,
“
Remote
communications interfaces”
- BAUD Sets the baud rate
- BITS Configures the number of bits
- PARITY Sets the parity
- FLOW-CTRL Configures the flow control
- ENABLE Enables and disables the RS-232 interface
TSPLINK
Configure the instrument in a TSP-Link
®
network Series 2600B Reference Manual ,
“
TSP-
Link system expansion interface”
- NODE Selects the instrument node identifier
- RESET Resets the TSP-Link network
UPGRADE Upgrades the firmware from a USB flash drive Upgrading the firmware (on page 5-4)
DISPLAY
Accesses display functions Front-panel tests (on page 5-3)
- TEST Runs the display test See Numeric entry method in Setting a
value (on page 3-19)
- NUMPAD Enables and disables the numeric keypad
DIGOUT Controls digital outputs Series 2600B Reference Manual ,
“
Digital
I/O”
- DIG-IO-OUTPUT Selects the digital I/O values
- WRITE-PROTECT Write-protects specific digital I/O lines
- LEGACY-MODE Sets digital I/O to work like an older
SourceMeter instrument
BEEPER Controls the key beeps Beeper (on page 3-21)
- ENABLE Enables the key beeps
- DISABLE Disables the key beeps
LINE-FREQ Configures the line frequency Line frequency configuration (on page 2-4)
- 50Hz Set the line frequency to 50 Hz
- 60Hz Set the line frequency to 60 Hz
- AUTO Enables automatic line-frequency detection during
start up
SYSTEM-INFO
Displays the system information System information (on page 2-4)
- FIRMWARE Displays the version of firmware installed
- SERIAL# Displays the serial number of the unit
- CAL Displays the last calibration date
- MEMORY-USAGE Displays memory usage in percentage
RESET-PASSWORD
Resets the system password Series 2600B Reference Manual ,
“ Password management”