Series 2600B System SourceMeter® instrument User's Manual
Section 3: Instrument description
2600BS-900-01 Rev. A / August 2021
3-19
Setting values
Through the front panel, you can adjust a value using either the
Navigation wheel method
or
Numeric entry method
(using the keypad).
Setting a value
To set a value using the navigation wheel method:
1. Use the
CURSOR
arrow keys (or turn the navigation wheel) to move the cursor to the digit that
needs to be changed.
2. Press the navigation wheel or the
ENTER
key to enter edit mode. The EDIT indicator is
illuminated.
3. Rotate the navigation wheel to set the appropriate value.
4. Press the
ENTER
key to select the value or press the
EXIT (LOCAL)
key to cancel the change.
5. To return to the main menu, press the
EXIT (LOCAL)
key.
To set a value using the numeric entry method:
1. If the keypad is disabled, press the
MENU
key, then select
DISPLAY > NUMPAD > ENABLE
.
2. Use the
CURSOR
arrow keys (or turn the navigation wheel) to move the cursor to the value that
needs to be changed.
3. Press the navigation wheel or the
ENTER
key to enter edit mode. The EDIT indicator is
illuminated.
4. Press any of the number keys (0-9, +/-, 0000) (see
2. SMU setup, performance control, special
(on page 3-3)). The cursor moves to the next digit on the right.
5. Repeat the above steps as required to set the values.
6. Press the
ENTER
key to select the value or press the
EXIT (LOCAL)
key to cancel the change.
7. To return to the main menu, press the
EXIT (LOCAL)
key.
To set a value to zero, press the
0000
numeric entry key. To toggle the polarity of a value, press the
+/
–
numeric entry key.
