Section 3: Instrument description
Series 2600B System SourceMeter® instrument User's Manual
3-18
2600BS-900-01 Rev. A / August 2021
The following table contains descriptions of the configuration menus and cross-references to related
information. To select a menu for single SMU instruments, press the
CONFIG
key and then the
front-panel key associated with the menu (see the description column in the following table). For
two-SMU instruments, press the
CONFIG
key, select the appropriate channel (CHANNEL-A,
CHANNEL-B) and then the front-panel key associated with the menu. To select TRIG and STORE
menus on two-SMU instruments, press the
CONFIG
key and then select COMMON instead of
selecting a channel.
To access, press the
CONFIG
key and then:
Options
For more information, see:
SRC
V-source sense and low range;
I-source low range; and
high capacitance mode
Series 2600B Reference Manual
, “Range”
“Basic source-measure procedure”
MEAS
V and I-measure range,
V-measure sense, low range, and
autozero
Series 2600B Reference Manual
, “Range”
“Basic source-measure procedure”
LIMIT
V-source and I-source compliance
limits
(on page 4-2)
SPEED
Measurement speed (NPLC)
Series 2600B Reference Manual
, “Speed”
REL
Set relative values
Series 2600B Reference Manual
, “Relative
offset”
FILTER
Control digital filter
Series 2600B Reference Manual
, “Filters”
OUTPUT ON/OFF
Set off-state, control digital I/O
(on page 4-31)
STORE
Set buffer count and destination
Series 2600B Reference Manual
,
“Source-measure concepts”
TRIG
Set trigger in, count, interval,
and delay
Series 2600B Reference Manual
,
“Triggering”
