Tektronix AVG1, User Manual

Page: 29 / 146

Operating Procedures
AVG1 Analog Video Generator User Manual
2- 5
Output Signal
The output signal is supplied on the two rear-panel serial outputs. To configure
the outputs, refer to
Appendix C .
If you disable the module output, it releases all system resources used by this
module.
1. Select the AVG1 Generator module, if not already selected.
2. Push the Test Signals button.
3. Touch Module Parameters at the bottom of the screen. The Module
Parameters window (shown on page 2--13) appears.
4. Touch the Output icon to toggle the state of the module’s output signal.
5. Touch Quit to exit.
Use the following procedure to select the module’s output test signal. You can
select any of the AVG1 signals that are loaded in your instrument.
1. Push the Signal Sets button to open the window shown below. Check that
there is an icon for each installed signal set. If your signal sets are not
installed, refer to
Signal Set Installation on page C--6.
Enable/Disable the
Output Signal
Select the Output Signal