Tektronix AVG1, User Manual

Page: 127 / 146

AVG1 Analog Video Generator User Manual
C- 1
Appendix C: Installation
This section contains instructions for installing the module into the TG 2000
Platform mainframe. Listed below are the major topics in this section.
H
Preventing component damage
H
Module installation (including signal set installation)
H
Signal backup and module removal
Preventing Component Damage
CAUTION.
Electrostatic discharge (ESD) can damage components on this module
and mainframe. To prevent ESD or other component damage, follow the steps
below when installing, removing, or handling modules:
1.
Wear a grounded antistatic wrist strap to discharge the static voltage from
your body while installing or removing modules from the TG 2000 Platform
mainframe.
2. Transport and store modules in a static-protected bag or container.
3. Do not slide the module over any surface.
4. Handle modules as little as possible.
5. Do not touch module components or connector pins.
6.
Do not use any devices capable of generating or holding a static charge in the
work area where you remove, install, or handle modules.
7. Avoid handling modules in areas that have a floor or work-surface covering
capable of generating a static charge.
8. Do not remove the module circuit board assembly from the shield. The
shield provides important support and protection for the surface-mount
components.