Tektronix AVG1, User Manual

Page: 136 / 146

Appendix C: Installation
C- 10
AVG1 Analog Video Generator User Manual
Signal Backup and Module Removal
Before removing a generator module, you should save the signal sets to a disk.
The AVG1 Generator module will lose its signal memory 30 seconds after you
remove it from the platform.
You will need a blank, DOS formatted 3.5 inch disk.
Save the signal sets as follows:
1. Insert a DOS formatted disk into the platform’s disk drive.
2. Push the Disk button and touch Save Signals to Disk .
3. Touch Select Source and select the AVG1 . Use the cursor arrows to select
the AVG1 module in the signals column.
4. Select Quit/Save .
5. Touch Select Destination and choose A: . If desired, create a new directory
for the signals by selecting New Dir and entering a DOS compatible name.
6. Create a new file by by touching New File .
7. Select Quit/Save to complete the transfer of signal sets to the disk.
8. Touch Start Save . Saving signals to disk may take several minutes
depending on the number and size of test signals.
To remove the module, follow these steps:
1. Turn off the platform by pressing the front-panel On/Standby switch and
switching the rear panel power switch to off.
2. Unplug the power cord.
WARNING.
To avoid a shock hazard always unplug the power cord before
removing the top cover. Failure to unplug the power cord can result in serious
injury or death.
3. Remove all top-cover screws and remove the top cover. See Figure C--2 on
page C--3.
4. Remove the appropriate rear panel as shown in Figure C--3 on page C--4.
Loosen, but do not remove the bottom screw. You will use it later to secure
the rear panel.
5. Refer to Figure C--6 on page C--6 and remove the top screw.
Required Equipment
Signal Backup
Module Removal