Tektronix 2252, Operator'S Manual, Page: 91 / 114

Operators Familiarization
COM FIGURE menu without answering the remaining question (s), press the
END button orthe CLEAR DISPLAY button. The CONFIGURE items are listed
as follows:
ACQUIRE IN PEAK DETECT MODE? {Factory Settings default is YES.)
Selecting YES selects the peak detect mode for the hardcopy. Acqui­
sition mode for the GPIB is selecting through the GPIB bus.
If NO is selected, the acquistion mode for the hardcopy is sample.
KEEP MENU ON WHEN MEAS’MT SELECTED? (Factory Settings
default is NO.) Selecting NO clears the measurement menu items from
the display after a measurement function is selected. Measurement cur­
sors remain displayed. The AUTO TRACKING MENU remains on after a
selection has been made.
Selecting YES allows a measurement menu to remain displayed after a
function is selected. The measurement menu items can be removed at
any tim e by pressing the CLEAR DISPLAY button once.
RECALL ONLY (IN STORE/RECALL)? {Factory Settings default is NO.)
Seiecting NO displays the Store/Recail Setup menu when the STORE/
RECALL SETUP button is pressed. From the Store/Recail Setup menu
you can store, edit, and recall front-panel setups.
Selecting YES displays the Recall Only menu when the STORE/
RECALL SETUP button is pressed. From the Recall Only menu you can
easily step through all of the stored front-panel setups.
KEEP MENU ON WHEN S/R SELECTED? (Factory Settings default is
NO.) Selecting NO clears the menu from the display when some store/
recall setup functions are selected.
Selecting YES keeps the Store/Recail Setup menu on the screen when
using the store/recall setup functions. The menu can be removed at any
time by pressing the CLEAR DISPLAY button once.
KEEP READOUT ON IN SGL SEQ? (Factory Settings default is NO.)
Seiecting NO will keep the readout off in Single-Sequence Trigger
Mode. This mode is useful for single-sequence waveform photography.
The readout is displayed briefly after the sequence is completed to
expose the film, then cleared to prevent overexposure.
Selecting YES keeps the readout on when in the Single-Sequence
Trigger Mode. This mode lets you view any of the measurements that
continue to be made during SGL SEQ trigger mode even if no waveform
is being displayed. The front panel control settings may also be made in
2252 Operators
3-35