Controls, Connectors, and indicators
Vertical
Refer to Figure 2 -2 for location of items 10 through 17.
@
CH 1 and CH 2 POSITION C o n tro ls —Adjust vertical position of the
Channel 1 and Channel 2 waveform displays.
11) MODE B u tto ns—Select the vertical channels for display (CH 1, ADD
channels 1 and 2, CH 2, CH 3, and CH 4). The CHOP/ALT MODE button
selects method for switching input channels on the display (chopped or
alternating).
Except for CHOP/ALT modes, pressing an unlit mode button turns on
the mode, and pressing a lit button turns off the mode. CHOP is selected
when the CHOP/ALT button is lit; ALT is selected when the button is not
lit.
CH 1, CH
2,
CH 3, and CH 4 —Select vertical channels for display. At
least one of the channels or ADD is always on and cannot be turned off
until another channel is first turned on,
CHOP/ALT—in the CHOP mode the display chops between selected
Input channels at a rate of about 625 kHz, In the ALT mode, the selected
channels are displayed in sequence (alternating at the end of each
sweep).
ADD—Displays the algebraic sum of the Channel 1 and Channel 2
input signals. The ADD display is in addition to any other selected chan
nel displays, in the ADD mode, a plus sign { + ) isdisplayed between the
Channel 1 and Channel 2 VOLTS/DIV readouts.
NOTE
In ADD mode when AUTO LEVEL TRIGGER MODE or CHOP
Vertical MODE is selected, the algebraic sum of Channel 1
and Channel 2 displays provides the internal signal source for
the trigger system when the trigger source is VERT,
2252 Operators
2 -3
Summary of Contents for 2252
