System Installation and Setup
Tek-CARE
®
500 System Components
NC510 and NC510ES Receivers:
The NC510 and NC510ES receivers connect directly
to the Tek-BRIDGE™ and receive calls from wireless devices in the facility. The NC510
receiver communicates with FA devices, and the NC510ES receiver communicates
with ES devices.
NC511ES Repeater/Locator:
The repeater/locator extends the range of roaming
transmitters and can determine the approximate location of a roaming transmitter
within the facility. An optional weatherproof housing (TekTone
®
part number IH511)
is available if the repeater/locator is to be mounted outdoors or if additional protection
for the repeater/locator is desired.
NC502 PC-Alarm Panel:
Interfaces between the Tek-BRIDGE™ and a POTS line for the
purpose of sending alarm messages to a central monitoring station.
NC369 Paging Transmitter:
When RF (Radio Frequency) paging is a required
component of a facility’s emergency call system, the NC369 Paging Transmitter is
used. The paging transmitter enables both automatic and manual pages to be sent to
NC399P Alphanumeric Pagers.
NC399P Alphanumeric Pager:
The NC399P Alphanumeric Pager receives automatic
and manual paging messages from the Tek-CARE
®
500 system sent by the NC369 Paging
Transmitter.
SF501ES Water Resistant Single Button Pendant Call Transmitter:
The single button
pendant call transmitter is a water resistant mobile transmitter that includes both a
belt clip and necklace. An alarm placed from the SF501ES must be reset by pressing
the recessed reset button on the reverse side of the pendant transmitter. To send a call
from the device, press the large call button for one second.
SF501/2ES Water Resistant Dual Button Pendant Call Transmitter:
The dual button
pendant call transmitter is a water resistant device that that includes both a belt clip
and necklace. An alarm placed from the SF501/2ES must be reset by pressing the
recessed reset button on the reverse side of the pendant transmitter. To place a call
from the device, press both buttons simultaneously for one second.
SF502ES Wall Mounted Call Transmitter:
The SF502ES Wall Mounted Call Transmitter
is a single-button emergency call transmitter. The alarm sent from the SF502ES
transmitter must be reset at the Tek-BRIDGE. The SF502ES may also be configured as
a resident check-in button, or the included necklace may be attached so that it may be
used as a portable transmitter.
NC505ES Remote LCD Receiver:
Used to connect external dome lamps and dialers to
the Tek-CARE
®
500 system, which gives additional annunciation capabilities beyond
the Event Monitor software on the Tek-BRIDGE™ The NC505ES is not dependant on
the Tek-BRIDGE™ to annunciate calls it receives, and does not annunciate signals from
the NC501ES receiver.
SF520ES Door/Window Egress Transmitter:
This transmitter is used to monitor door
and window activity. It may be used as wither NO (Normally Open) or NC (Normally
Closed) to allow use in a variety of applications. Alarms are either automatically reset
when the device returns to a normal state or when calls are reset at the Tek-BRIDGE™
depending on system programming.
4 • IL948 Tek-CARE
®
500 & Tek-CARE
®
550 Installation Manual
Copyright © TekTone Sound & Signal Mfg., Inc. All Rights Reserved.
