INSTALLATION
INSTALLATION
User’s Manual
User’s Manual
16
16
by
Ring/LAN
function from BIOS setup. (Please refer to
page 31
). This allows the modem
to remotely power on the system or return it to full power out of suspend/standby mode.
IrDA-Compliant Infrared Module Connector (JP4)
The IrDA connector bracket hooks directly to this connector on the
mainboard. This connector provides support for the optional wireless
transmitting and receiving infrared module. You must first configure
through the BIOS setup where UART2 is directed, COM2 or IrDA.
* Pin 6 is reserved for consumer IR.
Wake-up On LAN Connector (J12)
The Wake-up On LAN function will allow the network to wake up a
Soft Power Down (Soft-Off) PC. However, if your system is in the
Suspend mode, you can wake-up the system only through an IRQ or
DMA interrupt. To use the Wake-up On LAN function, you must
enable the “Power up By Ring/LAN” field in the Power Management
Setup of the Award BIOS. Connect the cable that comes with your
LAN card to location J12 on the system board. Refer to the add-in
card’s manual for details. Note: Your LAN card must support Magic
Packet in order to use the Wake-up On LAN function
.
