INSTALLATION
INSTALLATION
User’s Manual
User’s Manual
17
17
Power State Function (JPX1)
This feature will power-on the PC when power returns after a power failure. Set JPX1 to On
(short) to enable this function.
“PWRON After PWR-Fail” in the Power Management Setup must be set accordingly. Refer
to pages 31 and 32 for more information.
USB Connector
This 8-pin connector permits connection of two USB peripheral
devices directly to the system without an external hub.
PS/2
Keyboard and Mouse Connectors
These two connectors are located on the back panel of the
mainboard.
Floppy drives
The on-board floppy controller supports (2) floppy disk drives with the floppy ribbon cable
provided. Make sure the RED stripe on the ribbon cable is oriented towards Pin-1. Notice
the “twist” between the sets of connectors on the floppy cable. The floppy drive “A”
position is at the END of the cable, whereas floppy drive “B” is hooked to one of the
connectors on the other side of the twist. The cable provides both “Edge” and “Pin”
connectors for both the A and B positions to match the connector on your floppy drives.
USB
PS/2
Mouse
PS/2
Keyboard