Teknoware TKT6716C, Installation And Maintenance Instructions Manual

Page: 29 / 56

VOT 2; Rev 1.2; EN; 09.07.2013
TKT67C
– Installation and maintenance
29
5.3 Commissioning
All operations related to the system installation and commissioning must be performed by a
skilled electrician.
The two empty columns of the type label inside the central battery unit shall be marked with the
total load connected to the central battery unit and the nominal battery mode duration.
5.3.1 Setting of battery type and capacity
The charging current has been set to minimum at the factory. The battery type and capacity must be set
/ checked as follows:
1. Set the battery type and capacity with the recharge control unit DIP switch according to the
guidelines in the illustration below.
NOTE: The charging current and battery type must ALWAYS be set / checked based on the number of
ampere-hours (Ah) in the batteries used. Incorrect settings may damage the batteries. Battery sizes are
as shown in the sticker.
NOTE: THE CHARGING CURRENT SHALL ALWAYS BE SET WITH MAINS SUPPLY OFF. ONLY
ONE DIP SWITCH IS ALLOWED TO BE SWITCHED ON AT THE SAME TIME.