Teknoware TKT6716C, Installation And Maintenance Instructions Manual

Page: 16 / 56

VOT 2; Rev 1.2; EN; 09.07.2013
TKT67C
– Installation and maintenance
16
2 TESTING
Use this option to select a test to be started or
interrupted.
1 = Start of the luminaire test.
2 = Interruption of the luminaire test.
3 = Start of battery test for 2/3 of the time (the
same time as in the automatic test).
4 = Start of the battery test for the set operating
time (1 or 3 hours).
5 = Start of the battery test until the end of its
duration
– the battery will be discharged.
6 = Interruption of the battery test /
acknowledging of a battery fault.
7 = Stop the local controller function or the
BLINK mode.
8 = Start the local controller function.
9 = Start the BLINK mode.
10 = Reconfiguration.
To start or interrupt a test,
1. Go to the menu with the
MENU / OK button.
2. Press the BROWSE button until
the TESTING led is lit.
3. Press the SET button until the
value you wish to select shows in
the display.
For example 6 = Interrupt the
battery test.
4. Acknowledge by pressing the
MENU / OK button again.
The required action begins.
3 SETUP
Use this option to enable / disable the settings
locking to change the operational settings of the
central battery unit.
To enable / disable the settings
locking,
1. Go to the menu with the MENU /
OK button.
2. Press the BROWSE button until
the SETUP led is lit.
3. Press the SET button to select the
correct value (0=locking enabled,
1=locking disabled).
4. Press the BROWSE button to
acknowledge the selection, and
return to the operational settings.
When the settings locking is disabled,
you can change the operational
settings.
4 AUTO CONF.
Use this option to change the status of the
automatic configuration.
Value 0 = Automatic configuration disabled.
Value 1 = Automatic configuration enabled.
Values 2 and 3 = Not in use.
To change the automatic configuration
status,
1. Go to the menu with the
MENU / OK button.
2. Press the BROWSE button until
the AUTO CONF. led is lit.