10
4
–
Preparation For Use Of The Detector
Detector equipment should be made ready for combined use. For this the following steps should be followed.
1
- as shown in Picture 2 and picture 3 should be first made ready for use to be used as a coil. The coil the larger
coil to be used in the form of a square with the pipes to each other should be reviewed and should be
compressed. The small coil with the coil to be used must be installed on the coil holding arm, the retention arm
and the cable should be wrapped.
2
- The battery of the user as shown in Figure 4 and the left arm to hang by the neck.
3
- user detector as shown in Figure 4 should not exceed the main unit around your neck.
4 - small coils to be used, as shown in Figure 4, large bobbin
if 2 is to be used. a person with the help of the coil should be kept.
Attention! The metal detector near the area and high voltage environment
should not be employed.
5 - the detector Coil connector and the battery connector as shown in Figure 4
must be installed. This process is being performed while the battery first, then the coil must be installed. After this
process, the detector has become ready for use.
Figure 2
Figure 3
Figure 4