11
5
–
The Use Of The Detector
5.1
- searches with the small coil.
In a search to be made with a small coil that the detector is ready to use the tune button must be held pressed to
open. Delta pulse 3s Plus Tune button on the screen with the look of the logo should be left. During this time, the
detector's search coil must be kept in position. After the logo appear on the screen in the opening post will be
seen. The next sequence of this paper is to be seen at the 5 spot, and then the loading post will be seen.
Loading of the script under 1% than the 99% of loading a program to count information will appear. Upon
completion of the installation of the program the main screen of the detector will appear. The main screen
appears with the detector the detector is ready for use. If the detector 4. or 5. if the mode is to be used in the
detector must be made in the setting of this mode is taken into the soil. The adjustment of soil is a process that is
performed in two steps.This is the first step, Tunning, and the second Zero stop.
Ground Balance For Mode 4 :
Tunning coil 50cm from the ground when held in the air to make the tune button on the detector must be held
pressed. The tune button is held down on the screen while the tuning post will be deleted and all posts will be
seen in a window. Meanwhile, at the same time, indicating that up to the top of the coil should be kept above the
arrow mark will appear. Tunning during the process, the position of the detector coil should not be changed.
Tunning down the UP ARROW will give the direction when the process is complete. When the down arrow
appears, the detector's search coil to the position should be lowered. A short drive down the coil after it has been
downloaded, the arrow mark will be deleted and the ratio of mineral soil at the bottom of the frame where it says
Tunning it will be seen. After this process, the setting will be completed and you will come to the main screen of
the soil. When the main screen comes up, if necessary, Zero the process can also be done.
Ground Balance For Mode 5 :
Tunning coil 50cm from the ground when held in the air to make the tune button on the detector must be held
pressed. The tune button is held down on the screen while the tuning post will be deleted and all posts will be
seen in a window. Meanwhile, at the same time, indicating that up to the top of the coil should be kept above the
arrow mark will appear. Tunning during the process, the position of the detector coil should not be changed.
Tunning down the UP ARROW will give the direction when the process is complete. When the down arrow
appears, the detector's search coil to the position should be lowered. If the search coil is lowered to the position
of the coil back into the air when the buzzer sounds if the detector should be lifted and with the + button of the
mineral by increasing the level of the coil should be lowered back down. If the search coil is lowered to the
position of the detector when the coil is lifted into the air again cutting in and should be audio - button with the
coil by reducing the level of the mineral should be lowered back down. The voice coil up and down when it is
lowered when it is removed, this process must continue until a change in. The soil tuen when the setting is
completed by pressing the button again donulebilini the main working screen. When the main screen comes up, if
necessary, Zero the process can also be done.
Attention! In order to obtain high efficiency it is advised to use with the sound detector of the ground.
