Tekno RC NB48.4, Building Instructions

Page: 9 / 32

Stock Position
(”D” Block)
Stock Position
(”C” Block)
30.2
TKR1601
TKR1601
TKR1601
TKR5086
TKR5491 - 2.4mm
TKR5086
Note: Loosen the M3x4 set screw (TKR1601)
if the sway bar does not turn freely.
Note: Do not overtighten
TKR5049A
TKR8163
TKR8164
TKR5165
TKR8184
TKR5174
TKR1402
TKR1601
TKR5079A
TKR1522
TKR1522
M3x8mm Cap Head Screw
x2
TKR1525
M3x14mm Cap Head Screw
x2
Bag G
Rear End
*TKR5490 - 2.3mm
*TKR5492 - 2.5mm
*TKR5493 - 2.6mm
*TKR5494 - 2.8mm
*TKR5495 - 3.0mm
(Option)
Thread
Lock
Thread
Lock
TKR1525
TKR1533
M3x40mm Cap Head Screw
x2
TKR1238
M4x10mm Droop Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
x2
TKR1529
M3x20mm Cap Head Screw
x2
TKR1533
TKR1238
TKR1529
TKR1601
M3x4mm Set Screw
x6
Step
G-1
Step
G-2
Step
G-3
TKR5020
TKR1402
M3x8mm Button Head Screw
x4
TKR5165
Note: With these stock settings,
Anti-Squat = 2° / Rear Toe = 2.5°
For reference, with center dot
inserts in both braces,
Toe = 3° / Anti-Squat = 2°
Use a #19 drill bit or
4mm reamer to ream
arms until hinge pin
falls through freely.
9
Install the sway bar ball onto the
sway bar wire until the end of
the wire is flush with the ball
collar as pictured above.
Front
Rear
Pivot Ball Orientation