Tekno RC NB48.4, Building Instructions

Page: 12 / 32

Stock Position
(”B” Block)
Stock Position
(”A” Block)
30.2
TKR1601
TKR1601
TKR1601
TKR5086
TKR5081 - 2.3mm
TKR5086
Loosen the M3x4 set screw
(TKR1601) if the anti-roll bar
does not turn freely.
Note: Do not overtighten
TKR1601
TKR1522
TKR1522
M3x8mm Cap Head Screw
x2
Bag I
Front End
*TKR5080 - 2.2mm
*TKR5082 - 2.4mm
*TKR5083 - 2.5mm
*TKR5084 - 2.6mm
*TKR5085 - 2.8mm
*TKR5087 - 3.0mm
(Option)
Thread
Lock
Thread
Lock
TKR1525
TKR1238
M4x10mm Droop Screw
x2
TKR5049A
Pivot Ball Sway Bar
x2
TKR5079A
Stabilizer Ball
x2
TKR1529
M3x20mm Cap Head Screw
x2
TKR1533
TKR1529
TKR1238
TKR5020
TKR1601
M3x4mm Set Screw
x6
Step
I-1
Step
I-2
Step
I-3
TKR8162
TKR8161
TKR1522
TKR8286
TKR5165
TKR5049A
TKR5079A
TKR5165
TKR5165
TKR5165
Note: With these stock settings,
Kick Up = 12° / Arm Sweep = 0°
For reference, with center dot
inserts in both braces,
Kick Up = 10° / Arm Sweep = 0°
TKR1525
M3x14mm Cap Head Screw
x2
TKR1533
M3x40mm Cap Head Screw
x2
Use a #19 drill bit or
4mm reamer to ream
arms until hinge pin
falls through freely.
12
Install the sway bar ball onto the
sway bar wire until the end of
the wire is flush with the ball
end as pictured above.
Front
Rear
Pivot Ball Orientation