Tekno RC NB48.4, Building Instructions

Page: 5 / 32

TKR5075
TKR5012
TKR8152B
TKR5012
TKR5268
TKR1222
TKR1222
TKR1525
TKR1525
TKR1222
TKR1222
TKR1226
TKRBB05114
TKR1525
M3x14mm Cap Head Screw
x6
TKR1603
M5x4mm Set Screw
x1
TKR1222
13x16x0.1mm Diff Shim
x2
TKR1226
5x7x0.2mm Shim
x1
TKR1603
TKRBB05114
TKRBB05114
TKR8152B
TKR1226
TKRBB05114
TKR1603
TKR1525 TKR1525
Front
Rear
Note: flat spot
Note: flat spot
Note: The front and rear of
the car use different inner
bulkheads. The front is angled
whereas the rear is
only slightly angled.
*These may not be needed
*These may not be needed
*These may not be needed
*These may not be needed
Grease
Bag C
Front Gearbox
(overview)
Thread
Lock
Step
C-1
Step
C-2
Step
C-3
TKRBB05114
Ball Bearing (5x11x4)
x2
TKR1525 x6
5
Note Step C-2: To properly shim the diff, start by test fitting the diff with no shims and check for
side to side play. If no (or very little) play is present, then continue on to the next step. If you feel
excessive side to side play, then start by adding one shim on the gear side of the diff assembly. This
will move the mesh tighter and remove any play. If the mesh is too tight at this point, move the shim
to the other side. In some rare cases, two shims may be necessary.