EM00136064 rev. 2.1
7
Paragraph 4 – Setting the Maximum Flow
Programming Operation
-
-
-
Pump Functions
Max flow rate
Max flow rate
Max flow rate
P100%
P100%
F320s/m
PROG
-
+
-
+
-
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow. Changes can be made by pressing the
key,
then using the
keys to set the new value. Press
to confirm and return to the main menu
Paragraph 5 – Setting the Alarm Relay
Programming Operation
-
-
-
-
Pump Functions
Max flow rate
Alarm Relay
P100%
N.Open
PROG
+
-
This is used to set the alarm relay in the absence of an
alarm situation, if open (default) or closed.
Changes can be made by pressing the
key, then using
the
keys to set the new value. Press
to
confirm and return to the main menu
Paragraph 6 – Flow rate Calibration
Programming Operation
-
-
-
-
Pump Calibration
Pump Calibration
Automatic Cal.
Automatic Cal.
Automatic Cal.
Pump Calibration
0,23 cc/stroke
cc/stroke 0,23
Start 100 strok.
Strokes 100
ml 20
Manual
PROG
+
-
+
-
Pump Calibration
Automatic
The memorised cc value per strike appears in the main
menu. It can be calibrated in two different ways:
MANUAL – manually enter the cc value per strike using the
keys and confirm by pressing the
key
AUTOMATIC – the pump makes 100 strikes, which are
started by pressing the
key. At the end of this process,
enter the quantity sucked up by the pump using the
keys and confirm by pressing the
key.
The entered figure will be used in flow calculations.
