Hob models CG-Lux-75 2G and CG-Lux-86 3G
a re installed in the same way as the CGC 4G
AI AL, except for the staples which are
geometrically dif f e rent. The installation of
these hobs must be carried out in the way
shown in the drawing 15, depending on the
thickness of the work top.
Seal
Work top
Screw
Fastening clip
Quick-fix nut
CGC 4G
Once the hob position has been dimensioned,
the seal must be affixed (J) to the hob.
Fix the clamps (K) into the holes on the lower
p a rt of the case, as shown in drawing, by tighte-
ning the four screws supplied (ø4.2 mm).
The clamps (K) and seal (J) are supplied in the
packaging along with the hob. (See drawing 16).
If the unit below the hob is to be used to store
p roducts it must be situated at a distance of at
least 10 cm below the hob. Fur t h e rm o re, it must
be taken into account that the temperature in
the interior of the furn i t u re may rise to 60
o
C .
CONNECTING THE HOB TO THE OVEN
(Mod. CG.1 4G, CG.1 3G 1P and CGC 4G) OR
THE CONTROL PANEL
To connect the hob to the oven, four telescopic
universal joints are provided. (See drawing 17).
To make this connection, proceed as follows:
1
Disconnect from the mains supply (mod.
CG.1 3G 1P and CGC 4G AI AL).
2
Detach the telescopic universal joints by
p ressing the retention tab (marked PUSH)
using a thin screwdriver and extract the
extender a few centimetres.
3
Remove the four lockpins from the ends (B).
4
P a rtially insert the oven in its position, taking
c a re not to snag the telescopic universal
joints which are hanging from the underside
of the hob, and leave sufficient space to be
able to connect the other ends of the joints
to the rods at the rear part of the contro l
panel, before finally connecting the lockpins.
5
For the electrical connection between the
two appliances, connect the hob connector
to the oven connector (mod. CG.1 3G 1P
and CGC 4G AI AL).
11
Drawing 16
A
D
E
B
C
A
B
C
D
E
20 mm.
30 mm.
40 mm.
20
J
30
40
J
J
K
K
K
A
A
B
Drawing 15
Drawing 17
