Tek Drive TDS-F8, Instruction Manual

Page: 61 / 74

59
3- Digital & Analog Output Terminal Parameters
No. Parameter Name & Description Setting Range Default User set
3-01
Terminal FM
Analog Output
Selection
00- Frequency Reference 06- Terminal AIN
01- Output Frequency 08- OP-POT
02- Output A. 09- PID Input
03- Output V. 10- PID Output 1
04- DC Bus V. 11- PID Output 2
05- Output Power 07 & 12- Reserved
0
3-02
Terminal FM Analog Output % Gain 1~ 255% 100%(
☆
)
3-03
Desired Frequency Agree during ACC 0.0~ 400.0Hz 0.0Hz
3-04
Desired Frequency Agree during DEC 0.0~ 400.0Hz 0.0Hz
3-05
Frequency Agree Width 0.1~ 25.5Hz 2.0Hz
3-06
Multi-FUN
Output
(Terminals
RA-RB-RC)
Selection
00- During Run 20- During Restart
01- Zero Speed 21- OL1
02- FRQ Agree 22- OH
03- Desired FRQ Agree 23- OL2
04- FOUT Detection 1 24- RS-485 MOD ERR
05- FOUT Detection 2 25- RS-485 MOD Control
06- VFD Ready 26- During APO 1
07- Uv1 27- During APO 2
08- During B.B. (N.O.) 28- During APO 3
09- During B.B. (N.C.) 29- During APO 4
10- Fault 30- During APO 5
11- Over TRQ DET (N.O.) 31- During APO 6
12- Run CMD by OP
32- During APO 7
13- FRQ REF by OP 33- During APO 8
14- During REV operation 34- CTC achieves (N.O.)
15- FRQ REF loss 35- CTC achieves (N.C.)
16- Over TRQ DET (N.C.) 36- PID Error
17- Pulse Output (MO only) 37~ 38- Reserved
18- Timer Output
19- Uv pre-alarm (DBV<230V)
10
3-07
Multi-FUN
Output
(TMN MO)
Selection
0
3-08
Pulse Output Multiple 01~ 16 1
4- Digital & Analog Input Terminal Parameters
No. Parameter Name & Description Setting Range Default User set
4-01
Terminal AIN Analog REF % Gain
0.0~ 1000
(1000.0
*3
)
100.0(
☆
)
4-02
Terminal AIN Analog REF %
±
Bias -99.9~ 100.0 0.0(
☆
)
4-03
Terminal AIN Analog REF Signal Selection
0- 0~ 10V
1- 4~ 20mA
0
4-04
Frequency Reference Analog Input Characteristic:
0- 0~ 100
％
(Normal/ FWD) 2- -100~ +100 (FWD+ REV)
1- 100~ 0
％
(REV)
0