Tek Drive TDS-F8, Instruction Manual

Page: 51 / 74

49
2-2 Main Circuit Wiring, Peripheral Equipment and Note
Be su
re to connect MCCB or fuses between the AC main circuit power supply and VFD input terminals R/L1,
S/L2 (& T/L3) to protect the input wiring, whether a MC needs to be installed depends on the situation.
Where a residual current device (RCD) is used for protection in case of direct or indirect contact, only a Type B
RCD is allowed on the supply side of this product. Use a RCD of 200 mA/ 0.1s minimum.
Table 2.1 Mains Circuit Wiring and Peripheral Equipment
Type
F8-****E(3)
Rating
(A
）
Wire/ Cable (mm 2 )
MCCB*3 MC*3
Mains*1 Grounding Control*2
N0P4 3.2
2~ 5.5
2~ 5.5
0.5~ 2
TO-50E 15A
CN-11
N0P7 4.8 TO-50E 20A
L0P4 3.2
TO-50E 15A
L0P7 4.8
L1P5 7.1 3.5~ 5.5 TO-50E 20A
H0P7 2.9
2~ 5.5 TO-50EC 15A
H1P5 4
*1
：
Mains circuit include
Ｒ
(L1)
、
S(L2)
、
T(L3)
、
U(T1)
、
V(T2)
、
W(T3)
、
P/B1
、
B2.
*2
：
Control wiring is the control signal wire on control board.
*3
：
The types of MCCBs and MCs in the table are TECO product numbers, of course other brands with the same
rating can be used also. In order to reduce noise interference, please remember to install R-C surge
suppressors (0.1uf/1000VDC
，
10Ω/5W) at both ends of the coil of MC.