Unpack and Prepare Your Workspace
• If possible, assemble the equipment at or near the space in which you intend to use it to avoid moving it later .
• Unpack all parts and support materials . Set aside packing materials and clear your work area .
• Locate the Hardware Kits packaged with the manuals . They are labeled to correspond with the assembly process .
LET’S GET STARTED
Figure 1:
Align the Rear Linkage to the Base and
insert at the Base Joint .
NOTE:
Always hand tighten all hardware in each step before fully tightening with the wrench or screwdriver .
The Front, Back, Right and Left of the equipment is labeled in the drawing on Page 3 . The Left Upper Handle is
attached to the Base with a Cable . Use caution and
DO NOT
pinch or pull on the Cable to avoid damage during
assembly .
BASE ASSEMBLY
Figure 2
: Use the
Step 1 Hardware Kit
to attach the
Base to the Rear Linkage .
Hand tighten 4 × Bolts with 4 × Washers on the
Base Joint .
DO NOT
fully tighten the bolts with the wrench
at this time . This will be done later in the
assembly process .
Figure 3
: Align the Base Fork with the Rear Linkage
Arm by first rotating the Base Fork and then
rotating the Rear Linkage Arm on top so they
connect at the Fork Joint .
5
Figure 1
Figure 2
Figure 3
Step 1 Hardware Kit
Bolt (M8 x 20)
Washer (M8)
1
2
