Router Inalámbrico AW4062 4-port ADSL2+ Router User‘s Manual
Page 12 of 81
4. Software Configuration
User can change settings via PC’s WEB browser. The following sections describe the set
up procedures. After successful setting, when you power on the AW4062 Router, it will
boot up and connect to ADSL line automatically. The Router can provide PVC
(Permanent Virtual Channel) for “Bridge test” by default. The default configurations for the
system are listed below.
LAN IP address: 192.168.1.1
NetMask: 255.255.255.0
UART setting: 115200bps, 8 bits, no parity, 1 stop bit, no flow control.
VPI/VCI for ATM
o
8/32 for PPPoE
o
8/36 for PPPoE with Imagnio service
ADSL Line mode: Auto-detect.
4.1. Set your PC’s Ethernet port
AW4062 is an ADSL Router which support DHCP and default enable. You also can set
your computer IP Address as
192.168.1.x
within the same subnet as AW4062 (default IP
address is
192.168.1.1
) and netmask (default netmask is
255.255.255.0
). It can be done
thru the following way.
1. Click start > Control Panel
2. In the Control Panel, double-click Network Connections
3. Right-click Local Area Connection the click Properties
4. Select Internet Protocol (TCP/IP) then click Properties
5. The TCP/IP Properties windows appear. You can select obtain an IP address
automatically and click OK to have the AW4062 assign your computer an IP
address. Or you can enter the IP within the same subnet as AW4062.
6. If your Internet Service Provider (ISP) gave you Domain Name System (DNS)
settings, enter them in the Use the following DNS server addresses fields. If
you are not sure of your DNS setting, contact your ISP.
7. Click OK to finish the setting.
