Router Inalámbrico AW4062 4-port ADSL2+ Router User‘s Manual
Page 11 of 81
NOTE 1:
SPECIAL LED’s STATUS WHILE THE FIRMWARE IS BEING UPGRADED:
While is being upgraded the Firmware, all the LEDs with the exception of the Ethernet
led WILL BLINK IN GREEN AT THE SAME TIME DURING THIS PROCESS (if
wireless net was disabled, the WLAN LED will not blink neither).
After finishing the process all the LEDs will come back to the standard status with a
normal behaviour.
If during the firmware upgrading process the router detect a recoverable fail (punctual
fail in the uploading which it is posible to come back with no damage in the system), all
the LEDs with the exception of the Ethernet led will keep on in GREEN 15 seconds to
inform you about the fail produced. After this period of time, all the LEDs will come
back to the normal behaviour.
If during the firmware upgrading process the router detect an unrecoverable fail
(system fail impossible to come back: for example, corrupted file, or router
disconnected from the power supply while the firmware upgrading was in process), the
on LED (POWER) will keep in RED. In this case it is recommended to contact with the
technical assistance support.
NOTE 2:
RESET THE ROUTER TO DEFAULT PARAMETERS
If in any case you want to reset the configuration to factory default parameters, please
follow bellow steps:
Put a paper clip or a pen in the hole back called “RESET”.
Keep pressing internal button more than 10 seconds.
Stop pressing the internal button “RESET”.
Then, the router will be restarted.
This process takes 20 seconds. Check LEDs behaviour comparing with figure of
section “3.4. Indicators” to be sure the Reset process was finalized successfully.
