Tecnoware EVO DSP MM 10.0, User Manual

Page: 5 / 64

ENGLISH
UPS EVO DSP MM RM 1 User’s manual
User’s Manual - English
Safety Warnings
Read this manual carefully and completely before installing and using the TECNOWARE EVO DSP MM
Uninterruptible Power Supply, which, from here after, will also be referred to as UPS.
This manual should be kept close to the UPS and read before the UPS is installed and used.
The UPS must be used only by properly trained personnel. To ensure correct and safe operations, it is
necessary that operators and maintenance personnel observe the general safety Standards as well as the
specific instructions included in this manual.
Risk of electric shock: do not remove the cover. The UPS contains internal parts which are at a high
Voltage and are potentially dangerous, capable of causing injury or death by electric shock.
The electric installation has to be done by qualified personnel. Follow all the Safety Standards (CEI
Standards in Italy or IEEE elsewhere) for the Input/Output connections and for the right section of
Input/Output cables.
There are no internal parts in the UPS which are user serviceable. Any repair or maintenance work must
be performed exclusively by qualified technical personnel authorized by TECNOWARE. TECNOWARE
declines any responsibility if this warning is disregarded.
Warning to the technical personnel authorized for Service: since internal components are connected to
the batteries, they will remain powered, and therefore dangerous, even after the UPS has been
disconnected from AC power mains. Before any repair or maintenance work to the UPS unit, turn off the
Battery circuit breaker on the rear side of Battery Box unit and then disconnect the Battery cable.
CAUTION - HIGH BATTERY VOLTAGE AND RISK OF ELECTRIC SHOCK - the battery pack nominal voltage is
240 Vdc (there are 20 batteries series-connected inside the Battery Box unit).
It is compulsory to ground the UPS according to Safety Standards.
Risk of electric shock at the Output lines when the UPS is ON.
Risk of electric shock at the Output lines while the unit is connected to the AC utility line.
We recommend to use a dedicate AC Input/Output power line for the UPS.
Do not obstruct ventilation slots or holes and do not rest any object on top of the UPS.
Do not insert objects or pour liquids in the ventilation holes.
Install the UPS indoors, in a protected, clean and moisture-free environment.
Do not expose to the direct sun light.
Do not keep liquids, flammable gases or corrosive substances near the UPS.