ATTENTION
Due to the particular nature of the work, any anomalous condition during functioning or operation, w
hether related to the equipment,
the machine, or the action of lifting the material, must be immediately reported to the employer or to the site manager.
ATTENTION
During lifting operations, avoid oblique (slanted) pulls. These are dangerous and are difficult to control.
ATTENTION
Do NOT cool or place the magnet in water.
ATTENTION
The cycle time must be reduced in the event of operation with very high ambient temperature (> 50°c ) or in the case of movements of hot
materials.
5
USE OF THE HYDRAULIC MAGNET
5.3 OPERATION
5.3.3 REQUIREMENTS FOR CORRECT USE
The following is strictly prohibited:
1.
To pass, stand, operate, or manoeuvre underneath the hanging load.
2.
To allow the system to be used by non-qualified personnel.
3.
To use the system if not in suitable mental and physical condition.
4.
To use the system if not wearing suitable work clothing or personal protective measures.
5.
To operate without due attention during load lifting and movement.
6.
To put hands on the chain or hook during the tensioning phase.
7.
To leave the hanging load unsupervised.
8.
To move loads that are heavier than the nominal capacity and unbalanced loads.
9.
To make the load swing during movement.
10.
To use the system for pulling or dragging other items.
11.
To use the chains as an earth for welders.
12.
To use the system to keep elements bound to the ground in tension or lift bound loads.
13.
To cool the magnet with water.
14.
To change the range of the hook after having selected the load, resulting in an excessive slackening of the chain and cable.
15.
To bang the structure of the building or other machines and systems with the load.
16.
To use two or more pieces of lifting equipment at the same time to lift the same load.
17.
To use the system in unforeseen environmental conditions.
18.
To reach the "end stroke" areas at full speed during movement.
19.
To perform abrupt direction changes during lifting and movement.
20.
To perform temporary repairs or operations not set forth in the instructions.
21.
To use non-original replacement parts or those not recommended by the manufacturer.
22.
To entrust the maintenance and repair operations to individuals who have not been trained by the manufacturer.
23.
To abandon the system when work is complete without having activated the related safety procedures.
24.
To perform routine maintenance, inspections, or repairs without putting the system out of service and activating the related procedure
during maintenance.
25.
To use unsuitable equipment.
26.
To intervene without removing the lifted load and switch off the electrical connection and to activate the magnet before having it over
the load.
27.
To use the magnet as a hammer or mallet to align ferrous materials or as an element of demolition.
28.
To use the magnet on hot materials.
29.
To use the magnet with bare hands during service or after deactivation, to avoid possible burns.
30.
To lift loads anchored to the electromagnet with ropes, chains, etc.
31.
To make the load swing to deposit it out of the vertical position.
32.
To lift "guided" loads.
These prescriptions MUST be followed:
33.
Strictly adhere to the safety regulations in force in the country where used.
34.
Follow all danger and safety precautions.
Division: Tecnoter srl
Hyd. Magnet
LQMI
Ver. T
Page 25/38
Rev: 1.0a_En –
15/07/2018