Figure 3.10 shows connections of an Installation switch to
{INSTALL}
. The Installation switch can be mounted on the housing of the
perform „
Installation
” procedure without the need to enter the controller's menu. If the
{INSTALL}
input is activated for a few seconds the
Installation
”
procedure (see page 19).
CAUTION!
•
Before
{INSTALL}
switch can be used, the door parameters must be entered to
the controller using menu.
•
{INSTALL}
input is enabled by default.
3.10.
OPTIONAL TERMINAL POSITION CONTACT (DOOR OPEN)
Figure 3.11 shows the connection of the optional terminal position contact (NO type
contact connected to the
{END SWITCH}
input) to indicate the full opening of the door. Use of
such contact is optional as the
detects the terminal positions of door by detecting the
mechanical resistance at its terminal positions. This
{END SWITCH}
input is provided for
with the widest range of doors and control systems.
Fig. 3.11. Optional terminal position contact connection
CAUTION!
Remember to activate
{END SWITCH}
input in the controller's menu (see
parameter description at page 21).
13
J9
J8
1
2
3
4
5
1
2
END SWITCH
+15V
