-
OPERATORS MANUAL
Page 13
Gently move the Front Unit to lower position.
DO NOT
try to force it
beyond this position, and
DO NOT
reach the position with any
impact, as this may damage the SPINJET. Place the Media Roll into
the bearings of the roll attachment as illustrated on
Figure 21
.
Figure 21
Leave the SPINJET in lower position and load the Media following the
standard procedure and instructions of the printer display. Be careful
to carry out the alignment of the Media correctly (refer to the section
‘Load and unload Media’ in the Pocket Guide for further instructions
on how to load Media).
When the Printer has completed the normal roll loading procedure,
the Front Unit must be gently raised to the upright position.
DO
NOT
release the grip of the Front Unit before it rests against the
Printer, as this may damage the SPINJET.
3.2
Trim Waste Strips
Occasionally the Printer produces trim Waste Strips. E.g. when
executing the command ‘Form feed & Cut’ or when a print is
cancelled.
Trim Waste Strips must be removed from the SPINJET immediately,
as they may cause paper jam.
Tilt down the Front Unit and remove the Trim Waste Strip from the
SPINJET manually.
Insert into bearing
