-
OPERATORS MANUAL
Page 11
2. Tilting the Front Unit up and down
Pay special attention to following points when tilting the Front Unit
up and down:
Gently support the Front Unit when moving from lower to upper
position. Insufficient support may damage the Front Unit.
Do not release the grip until the Front Unit rests against the
Printer in the upper position or when it is fully lowered.
Stop tilting down the Front Unit when a resistance is felt.
DO
NOT
try to force it beyond this position, and
DO NOT
reach the
position with any impact, as this may damage the SPINJET.
Please note:
Printing will be inhibited with the Front Unit in the lower position.
An Error 01 will occur if sending a print job and the Front Unit is
in lower position. Please refer to
Section 6. Troubleshooting
.
Tilting up the Front Unit must only be done when the Printer is
when ‘Ready’ is indicated on the Printer Control Panel. An Error
02 will occur if moving the Front unit to lower position during a
print job. Please refer to
Section
6. Troubleshooting.
Leave the Front Unit in upper position when the Printer carries
out a calibration.
The Front Unit must be left in the upper position when
unattended.
2.1 Mounting
spacer blocks
The Spacer Blocks must be used every time the Front Unit is
dismounted.
Tilt down the Front Unit and hold the two Spacer Blocks in gap
between the upper and lower leg.
DO NOT
put fingers into gap
between the upper and lower leg.
Gently tilt up the Front Unit so it rests against the Spacer Blocks.
Make sure that the Front Unit rests firmly on the Spacer Blocks
The Spacer Blocks must be used every time the Front Unit is
dismounted.
Figure 18
Spacer
Block
