52
3. Operation & Setting
51
*
NGRAB STREAMING SETUP
Press the [MENU] button to go to the Main Menu. Go to - (6)
Setup
(6)
Expert Setup
(2)
Ngrab Streaming Setup
.
The Ngrab Server is used to record a movie over the Network to another
PC. First install the Ngrab Server Software on a PC and configure it.
Srv IP
: Enter the IP-Address of the PC on which the Ngrab Server Software
runs.
Srv MAC
: The Ngrab Server Software must be started and configured
before detecting the MAC-Address of the PC. Press the [
BLUE
] button to
detect the MAC-Address.
Srv Port
: Enter the Server Port-Address which is configured in the Ngrab
Server Software. The MAC-Address is used for the WOL (Wake On LAN)
function, which must be supported by the PC’s NIC (Network Interface
Card). You can configure a PC to use full APM (Advanced Power
Management). The PC awakes upon access through the NIC and the Ngrab
recording starts.
*
SOFTWARE UPDATE
SOFTWARE UPDATE VIA INTERNET
Press the [MENU] button to go to the
Main Menu
. Go to - (6)
Setup
(6)
Expert Setup
(3)
Software Update
(1)
Internet Update
Internet Software Update only works if you have configured the Network.
This window shows the currently installed Software. The latest software
version/release is always on the top of the list. Select the Software you want
by pressing the [OK] button and following the on-screen instructions.
SOFTWARE UPDATE VIA FTP OR SAMBA
Press the [MENU] button to go to the
Main Menu
. Go to - (6)
Setup
(6)
Expert Setup
(3)
Software Update
(2)
Manual Update
If the TM-500/600 is not connected to the internet but is configured for
Network LAN, yoo can manually update by FTP or Samba. Select the
Software you want by pressing the [OK] button and following the on-screen
instructions.
SOFTWARE UPDATE VIA SERIAL (RS-232C) CABLE
1.Download Technomate Control Center Loader Program from
www.technomate.com
2.Turn the TM-500/600’s AC Power Off
3.Hold the OK button on the front panel, and whilst still holding the
OK Button, turn the AC Power On. A black screen (uboot) will appear.