TECHNO-GAZ ONYX B 5.0, Technical Manual

Page: 95 / 235

ENGLISH
18
05 PRINCIPLE OF OPERATION
The following describe an
OPERATING CYCLE
and a
VACUUM TEST CYCLE
(refer to
the user manual for the timing of each cycle that the autoclave can make).
PREHEATING
The autoclave is equipped with a fully automatic preheating function that speeds up the
operating cycles of the autoclave.
After having installed the machine and removed the accessory kit form the chamber, turn
on the device moving the button on the side of the control panel
(X) in position – I – and
open the door.
When the autoclave turns on the display shows the name of the machine and then a check
of the devices status with the firmware release.
After a few seconds the displays show the main screen of the machine followed by a beep,
indicating the effective barometric alignment.
The preheating is triggered in all operating and test cycles
with the exception of the
VACUUM TEST
where it will remain switched off. In this phase the resistance brings the
temperature of the chamber surface at a temperature of 80°.
Prepare the instruments to be sterilized, place them on the appropriate tray and on the tray
holder seats and insert everything inside the chamber and close the door manually by
turning the close lever.
CAUTION BURN HAZARD
Autoclave in pre-heating
Select the desired cycle by pressing SELECT to scroll the cycles.
When the desired cycle is highlighted, press the Start key in correspondence of the
multifunction keys to start the cycle.
All the sterilisation cycles involve 3 vacuum stages except for the Safety Cycle that
only features 2 vacuum stages, switching from vacuum 1 to vacuum 3.