3
Operation and Safety
➜
Apply slight pressure to the marked spot in order
to open the back cover of the remote control unit.
➜
Insert the batteries supplied with the set, ensuring
that their polarity complies with that indicated in
the battery compartment.
➜
Now, close the battery compartment again.
➜
Press the
TV
key, in order to switch over to TV
control level. If you forget this step, theTV set will
not respond to keyed instructions.
Note !
➫
The TV key must be pressed after each time
the batteries have been changed, in order to
reset the operating code for the set!
➫
If batteries have been in use for some time, and
are nearing the end of their life, there may be mal-
functions of the remote control.
➫
We recommend that you use Micro AAA/R3 alkali-
ne batteries for the remote control.
➫
Spent batteries must be disposed of correctly, or
handed to your retailer.
➫
The remote control can be used to operate the TV
set, a video recorder as well as two satellite recei-
vers, provided they utilise specific addresses of
the so-called "RC 5 code" (e.g. digital satellite
receivers from TechniSat -TV).
➫
The keys
PIP
,
ZOOM
,
?
and
INFO
allow you to
operate the Rewind, Stop, Play and Fast Forward
functions of a video recorder.
➫
The
EPG
key on the remote control is of no signifi-
cance.
The set is set at the factory for a menu-driven
initial operation (programming channels). All
available channels are scanned, then sorted
and retained in memory in a logical order.
The following steps must be followed:
➜
Connect the antenna cable to the antenna socket
at the rear of the TV set.
➜
* Connect F-connector of the antenna cable to the
F-socket of the TV set (only if satellite module is
fitted).
➜
Connect power plug to the power supply.
➜
Switch on the TV set via the power switch on the
TV control panel.
The power control light will light up in green.
After a short time, a menu for selecting your
prefer-
red language
will be displayed on the screen.
➜
Use the
Programme
keys on the remote control
unit to select the language (e.g. English), and con-
firm by pressing
OK
.
The menu
Land (Country)
will now be displayed.
➜
Use the
Programme
keys to mark the country
(e.g. GERMANY), confirm by pressing
OK
this will
initiate the TTS scan.
TTS is an automatic scan and search for all pro-
grammes available.
The channels/stations found will be displayed in a
list.
* If the TV set is fitted with a
satellite modu-
le
, the satellite channels found will be added
to the list of terrestrial or cable channels
found, in accordance with the enclosed list of
channels in this manual.
* If the TV set is fitted with an
ADR module
,
the pre-programmed ADR stations will be
added above programme position 351 (first
ADR station slot = 351 plus the number of
terrestrial resp. cable channels.
At the end of the scan, all programmes have been
found.
The menu
Change Order
will be displayed.
➜
Pressing the
RADIO / TV
key will switch off the
menu.
➜
Pressing the
Standby/on
key will keep the TV set
in standby mode.
➜
Pressing the
Standby/on
key will switch on the TV
set.
Switching the set on at this time will lead to
the internal clock of the TV set being set to
the time of the tele text clock of the channel
on programme slot 1.
Your Initial Operation has been successfully con-
cluded.
Remote control / changing batteries
Initial Operation
Any characteristics marked with * are fun-
ctions that are not available in all TV
models covered by this manual.
