5
3
1
2
4
5.
SETUP INSTRUCTIONS
•
Connect the fluid reservoir feed tube (1) to the valve inlet port (2).
•
Connect the valve airline (3) to the valve controller or other pneumatic device that is used to
control the valve.
•
Connect appropriate nozzle or dispensing tip (4) to the fluid outlet port.
•
Set the valve controller pressure at 70 psi (4.8 bars)
•
Set the fluid reservoir pressure. Do not exceed 2,500 psi (172 bars)
•
Make sure all connections are tight
•
Place container under the valve outlet and activate the valve until the fluid flows steady.
The amount of fluid that flows through the valve is determined by:
•
Valve open time
•
Fluid reservoir pressure
•
Dispensing tip size
NOTE:
Techcon makes an available an adjustable “suck-back” cap part number 934-003-000
Figure 3.0