Tech Source RAPTOR 1000 - OPENWINDOWS FOR SOLARIS INSTALLATION-REFERENCE, Installation And Reference Manual

Page: 34 / 68

Raptor OpenWindows for Solaris Installation and Reference Manual
4-8
4. Power off the system
5. Connect your monitor cable to the onboard VGA connector
on your system back panel
6. Power on the system.
4.6.1.2 Ultra 5 and Ultra 10
To use the Raptor as the system console on an Ultra 5 or Ultra
10 as the only framebuffer, first disable the graphics device
which comes built-in to the Ultra 5 and Ultra 10.
At the
ok
prompt, type:
ok setenv pcib-probe-list 1,3
ok reset-all
Once the system is reset, all console messages will be directed
to the Raptor card.
4.6.1.3 Sun Blade 1000, Sun Blade 2000, Ultra 80, E250 and
E450
If no other framebuffers are present in a Sun Blade 1000, Sun
Blade 2000, Ultra 30, E250, or E450 then the Raptor will be the
console by default, provided the board is in a valid probed PCI
slot.
NOTE: To restore the motherboard’s graphics device as the
console for any reason, simply add it back to the
pcib-
probe-list
as below:
ok setenv pcib-probe-list 1,2,3
ok reset-all