4
Revised 08/04
Installation..................................................4
General Overview
Permanent Installation
Assembly ....................................................5
General Overview
Tools Required
Side-shelf
Pedestal Base
In-ground Post Base and Bolt-down Post Base
Cabinet Base
Roll Back Hood
Cooking Grids and Baking Rack
Gas Connection......................................................8
General Overview
LP Gas Cylinder Safety
Installing Your LP Gas Cylinder
Removing Your LP Gas Cylinder
Quick Disconnect Instructions
Permanent Installation
Gas Leak Test
Operation............................................................11
General Overview
Burner Ignition
Burner Ignition Without Pilot
Low Heat Adjustment
Pilot Flame Adjustment
Base Brake
Hazardous Locations and Conditions
Infra-red Cooking ..................................................14
General Overview
Infra-red Searing Method
Helpful Hints in Cooking
Flame Flare-up Control
Sample Cooking Methods
Maintenance and Cleaning ......................................16
General Overview
Protection of Burners
Cleaning
Maintenance
Replacement Parts
Appendix A: Build-in Specifications............................18
Appendix B: Accessories ........................................20
Rotisserie
Bar-B-Que Tray
Wood Chip Smoker
Deep Fryer/Steamer
Griddle
Wok
Sterling
®
Side-burner
Appendix C - Replacement Parts................................28
Appendix D - Troubleshooting ..................................29
General Overview
WARNING:
THIS GRILL IS DESIGN CERTIFIED FOR USE
OUTDOORS ONLY.
THIS GRILL SHOULD NOT BE USED IN A BUILDING,
GARAGE OR OTHER ENCLOSED AREA AND IS NOT
INTENDED FOR USE ON RECREATIONAL VEHICLES OR
BOATS.
The Sterling
®
is designed for permanent installation on a
free-standing masonry or other suitable patio fixture. See
Appendix A for complete build-in specifications.
The Sterling can also be attached to the optional pedestal
or cabinet base, which have casters for easy movement. It
can be locked in place by using the brake mechanism,
WHICH SHOULD BE ENGAGED AT ALL TIMES
located near
the back left corner of the pedestal base or inside the
cabinet base at the back left corner. (See
BASE BRAKE
section on page 13 for more information.)
Figure 1 (see page 5) represents the minimum clearance
of a mobile grill to any adjacent combustible
construction.
WARNING:
THIS OUTDOOR COOKING GAS APPLIANCE
SHALL NOT BE USED UNDER OVERHEAD
COMBUSTIBLE CONSTRUCTION.
Permanent Installation
If you are installing your grill as a build-in or on the
optional Post Base (Sterling II only), it should be located
so the ventilation louvers remain clear of all obstructions.
The louvers are located in the front surface of the Grill’s
Housing and at the rear of the Roll Back Hood. Any
accumulation of debris will restrict the flow of
combustion and/or ventilation air, and may result in
improper burner operation or overheating. See Table A.1
for clearance specifications. Installation procedures
relating to gas connections for permanent installations
can be found in the Gas Connection section of this
manual. Build-in opening specifications can be found in
Appendix A of this manual.
Table A.1
Clearance Specifications
COMBUSTIBLE
NON-COMBUSTIBLE
CONSTRUCTION
CONSTRUCTION
Sides
12"
0"
Back
12"
0"
Contents
Installation
