TEAMWELDER Plasma CUT 105, User Manual

Page: 56 / 64

User manual 56
Solution to basic problems
Problems Cause/solution
On the display appears “VOO” message. The plasma arc is extinguished for lack of
material to be cut.
10. 10.1
11. 11.1 On the display appears“TOR” message.
Consumables are stuck or worn.
Turn the power OFF and check
consumables assembly line.
Technical questions
If you cannot solve a problem by following this basic troubleshooting guide or if you need further
assistance:
1. Call your dealer or authorized service center.
2. Call the nearest office listed at the beginning of this manual.
3. Seek the service manual for the CUT 65 - 125, where you will find wiring diagram,
troubleshooting and high level information lists more pieces.