TEAMWELDER Plasma CUT 105, User Manual

Page: 3 / 64

User manual 3
CNC - Activating an external AC coil with an external power supply. 30
CNC - Activating an industrial isolated module with an external power supply. 31
OPERATIONS 32
Controls and indicators 32
Control panel 33
Torch consumables installation 34
Torch consumables configuration 34
Torch parts 35
Torch consumables configuration (continued) 36
Torch parts 37
Mode selection 38
Check and adjust the gas pressure and current ( power ) 39
Operating the manual torch 40
Fix the mass clamp 41
Cutting start from the edge of the piece 41
Hand torch cutting technique 42
Piercings 43
Gouging 44
CUTTING CHART 45
Mechanized unshielded consumables for 45 Amps 45
Mechanized unshielded consumables for 65 Amps 46
Mechanized unshielded consumables for 85 Amps 47
Mechanized unshielded consumables for 105 Amps 48
Mechanized unshielded consumables for 125 Amps 49
MAINTENANCE 50
Routine maintenance 50
Consumables inspection 51
Replace the gas filter element 52
Disconnect electrical power and gas supply. Remove the filter bowl. 52
Remove the filter element from the filter housing.
52
Install the filter bowl. 52
Controls and indicators 53
Lighting indicators 53
Solution to basic problems 54
Electric system circuits draw 57
PARTS 58
Configuration of the torch consumables 58
Configuration of the torch consumables (continuation) 59
DECLARATION OF CONFORMITY 60
DOC TW CUT 65 60
DOC TW CUT 85 61
DOC TW CUT 105 62
DOC TW CUT 125 63
MANUFACTOR AND DISTRIBUTOR INFORMATION 64