122
104
118
19
20
B
B
B
B
BA
A
A
A
AG D (Contin
G D (Contin
G D (Contin
G D (Contin
G D (Continued)
ued)
ued)
ued)
ued)
15
Figure D-7
Step D-7
Step D-7
Step D-7
Step D-7
Step D-7
Figure D-6
1. Thread a 4-40 x 1/8" Set-Screw(134) into each hole on the
bottom of the Rear Pivot Block (104). Just thread it in far enough to
start the Set-Screw, it will be tightened in the next step.
Step D-6
Step D-6
Step D-6
Step D-6
Step D-6
IMPORTANT NOTE: The Rear Pivot should be installed so that
the Set Screws are Tightened from the Bottom of the Chassis, also the
word "TOP" molded into the Rear Pivot Should be installed towards
the front of the truck.
1. Position the rear Pivot Block (104) onto the rear of the Chassis
and line up the mounting holes in the Chassis and rear Pivot Block.
The word "TOP" is molded on to the upper front portion of the rear
Pivot Block.
2. Thread a 4-40 x 3/8" Flat-Head Screw through the bottom of
the Chassis and into each of the 4 mounting holes in the rear Pivot
Block.
3. Position the rear Arm (118) inside the ears on the rear Pivot
Block and line up the holes in the rear Arm and Pivot. Slide a rear inner
Hinge Pin (122) through the Rear Arm and Pivot until the end Hinge
Pin is flush with the front face of the Pivot.
4. Snug the two 4-40 x 1/8" Set-Screws (134), which were installed
in Step D-6, to keep the Hinge Pin from working lose, these Set-
Screws do not need to be very tight.
5. Repeat for right Rear Arm assembly.
122
20
Rear Pivot Set Screw Install:
Rear Suspension Install:
134
134
104
134
Summary of Contents for XXX-NT AD2
Page 65: ......
