176
175
30
29
175
174
180
171
Ba
Ba
Ba
Ba
Bag H
g H
g H
g H
g H
(Contin
(Contin
(Contin
(Contin
(Continued)
ued)
ued)
ued)
ued)
CUT
Figure H-15
1. Cut an 10.5" (280mm) length of Fuel Tubing (176) from the
piece supplied.
2. Cut one end of the 10.5" piece of Fuel Tubing at a 45
o
angle as
shown in Figure H-15A. Install the uncut side of the tubing to the
forward fitting on the top of the Fuel Tank (30).
3. Wind the Fuel Tubing into a small loop and insert it into the
rectangular slot in the chassis brace (29) as shown and clip the Fuel
Line into the Fuel Line Clip (84) on the Chassis. Insert the cut end of
the tubing into the inside (small) hole in the tuned pipe. This fuel line
will serve as the fuel tank pressure line.
4. Attach one end of the Fuel Tubing to the rear fitting on the top
of the Fuel Tank, and attach the other end to the fitting on the carbu-
retor. This will be your Fuel Line.
IMPORTANT NOTE: Make sure that the cut section of
Fuel Tubing is inserted all the way into the Tuned Pipe.
Figure H-15A
Step H-15
Step H-15
Step H-15
Step H-15
Step H-15
40
Figure H-14
Step H-14
Step H-14
Step H-14
Step H-14
Step H-14
1. Secure the Tuned Pipe (175) to the Coupler (174) by wrapping
an 8" Tie Strap (180) around the Coupler, and the pipe, and tighten.
2. Secure the Coupler to the Exhaust Header (171) by wrapping
another 8" Tie Strap around the Coupler and Header and tighten. Cut
off the extra length from both Tie Straps.
Pressure and Fuel Line Install:
Coupler Tie Strap Install:
Summary of Contents for XXX-NT AD2
Page 65: ......
