31
9
164
119
EQUAL THROW IN
BOTH DIRECTIONS
1. Install the carburetor to the engine as per the instructions
supplied with the engine. The carburetor throttle arm should be on
the left side of the engine as shown. Check that the arm has equal
throw from center, as shown in Figure H-7A. If the arm rotates more
in one direction, loosen the nut securing the arm and re-position the
arm.
*NOTE: If your engine comes equipped with a slide valve car-
buretor, the slide ball should be positioned to the left side of the
engine pointing up and forward.
2. Tighten the carburetor locking screws or other mechanism per
the instructions included with your engine.
Figure H-7
Step H-7
Step H-7
Step H-7
Step H-7
Step H-7
Figure H-7A
Ba
Ba
Ba
Ba
Bag H
g H
g H
g H
g H
(Contin
(Contin
(Contin
(Contin
(Continued)
ued)
ued)
ued)
ued)
36
1. Place a Ball Stud Washer (9) over the four 4-40 x 1/2" Cap-Head
Screws (31). Insert a 4-40 x 1/2" Cap-Head Screw through the four
holes in the engine as shown.
Use Thread-lock compound on the threads of the
Screws for the Engine Mounts to prevent the Screws from backing
out.
2. Attach the engine to the Engine Mounts (164) by threading
the four Screws into the four holes shown.
*NOTE: The two Engine Mounts should be positioned with the
narrow end up as shown in Figure H-6.
IMPORTANT NOTE: Make sure that the Engine Mounts are
installed correctly as indicated in Figure H-6. The larger holes should
be positioned toward the front of the engine, and the four Screws
should be installed into the smaller holes.
*NOTE: Engines equipped with pull starts can be installed in
the XXX-NT AD2, in the same fashion as a non-pullstart engine.
Step H-6
Step H-6
Step H-6
Step H-6
Step H-6
Figure H-6
Engine Mount Install:
Carburetor Install:
9
31
Summary of Contents for XXX-NT AD2
Page 65: ......
