Operation of the TEAM UHF-Handy
The TEAM UHF-Handy offers you the possibility to commu-
nicate in a band of your choice out of two radio bands in the
70-cm-band ( UHF ). One band is the PMR band ( 446.00625
MHz – 446.09375 MHz ) and the other one the LPD band
( 433.075 MHz – 434.775 MHz ). The TX output power is
automatically matched to the allowed maximum value of the
actual selected band. This is 500 mW radiated TX output
power in PMR operation and 10 mW radiated TX output
power in LPD operation. The actual selected band is indica-
ted by the letter on the upper left corner of the main screen.
The P means PMR mode and the L means LPD mode.
If the unit receives an audible signal of a station the symbol
R ( E ) appears in the lower left corner of the main screen.
The following functions have to be selected from the main
screen ( main menu ).
1) Band and channel selection
To select another radio band depress out of the keys ( 4 )
Down
▼
7 times or Up
▲
once. The display shows the writ-
ing CH. Then depress briefly the confirmation and On/Off key
( 5 ). Then the display shows the writing . On the left
side of the writing CH you see an arrow, which can be moved
with the help of the Up/Down keys ( 4 ) either to the left side
of the writing Band or back to the left side of the writing CH.
For the activation of the band selection put the arrow to the
left side of the writing Band and then depress the confirma-
tion key ( 5 ). Then the display shows the writings or
, depending on which one of the two bands the actual
band is. With the help of the keys ( 4 ) you can toggle bet-
ween both indications. Then, depress the confirmation key
( 5 ) for the final selection of the indicated band. Now the dis-
English
English
27
TEAM ORM-MS. While the socket is used the internal spea-
ker ( 6 ) and the internal microphone Mic ( 7 ) are switched
off.
9) Battery indication
The battery symbol appears at the main screen at the
position D. In case of completely charged batteries it is com-
pletely filled-in. At 4.9 V supply voltage one third of the filling
disappears, at 4.6 V one other third, and at 4.1 V there is
only the frame remaining. At 3.8 V the frame starts to blink at
last. Now it is time to change or charge the batteries or
accus, otherwise errors of functions and displayed informati-
on may occur. The current consumption in transmit mode
amounts to 270 mA ( PMR mode ), 100 mA ( LPD mode ), in
reception mode with closed squelch 40 mA and in power
save mode 15 mA.
10) Power save function
The power save mode is only active in reception mode. If the
squelch is not opened by a signal for at least 20 seconds,
and if there is no key entry during this time, the unit falls into
the power down mode. In this mode the receive section is
supplied only periodically for a short time, so that the current
consumption goes down from 40 mA to 15 mA. On receiving
of a signal or pressing any key the power save mode swit-
ches itself off again.
11) Receipt tones
If a signal is found on the actual channel in PMR or LPD ope-
ration the receipt tones are switched off. Otherwise every
pressure of a key is indicated by a short tone.
26
Manual_UHF-Handy 18.07.2003 16:53 Uhr Seite 26
