on every occupied channel, where the squelch opens, for 10 seconds. If there is in the
demodulated signal also a CTCSS tone, it will show also the corresponding CTCSS code
number. 10 seconds later or after the signal has dropped below the squelch threshold the
channel scan function continues searching. By pressing the confirmation key ( 5 ) the
channel scan function is terminated and the unit remains on the actual channel. If the unit
has been on an occupied channel where a CTCSS coded station has made a transmis-
sion, the display will take over this CTCSS code. If the station had no CTCSS code or the
channel was free, the unit keeps the CTCSS setting which has been active before start-
ing the channel scan.
9) Transmitting:
For speech transmission depress and hold the transmit key PTT ( 9 ) on the left side of the
unit. In the display appears the symbol ( D ). If the channel scan function had been
active, it would be terminated now. The sensitivity of the built-in microphone Mic
( 7 ) has been set to give good results speaking normally at a distance of 2 inches.
Speaking too loudly will cause distortions and make the signal difficult to understand. On
completion of the transmission release the transmit key PTT ( 9 ) and the unit will revert to
receiving mode and in the display the will disappear. For call melody transmission on
the actual channel depress the call tone key CALL ( 10 ) above the PTT key. The unit trans-
mits the actual call melody in full length, no matter how long you press the call tone key
CALL ( 10 ). It is only audible at the counter station. In the display appears ( D ). Speech
transmission is impossible now. After finishing transmission the unit switches back to
receiving mode with a short melody in the speaker ( 6 ) and in the display will disappear.
English
34
T
T
T
T
