Brushless motor
With the motor attached to the motor mount, feed the wires through middle of the mount. If needed,
change the bullet-connectors to match the speed controller. Cover the wires with the small square foam
piece.
Plug in the wires to the ESC and remember to swap any two to change the direction of rotation, if needed.
Propeller
It is recommended to use a folding propeller to reduce drag while gliding and minimizing propeller
damage on landing.
Install the propeller using the following layering; prop adaptor (if used), propeller, washer and lock-nut.
Add a drop of threadlock on a non-lock nut. Make sure the top side (with printed logo) is facing the front of
the wing and that the propeller in the right direction. To change the direction of rotation of the motor,
switch 2 of the 3 cables going to the speed controller.
Before installing a regular non-folding propeller, balance it to reduce vibrations from propagating to the
HD recording camera.
Battery
The battery bay has two support straps to properly secure the battery and a cable exit cut-out for a nice
flush finish when using compatible batteries. Any size battery can be used, but it must be smaller than
W60 x H44 x L165 mm, suggested size W48 x H36 x L150 mm. And weight max. 550 grams and 525 grams,
respectively. It is recommended to use 14 AWG rated wires and XT60-connectors.
23
