15
1. Names and functions of parts
u
Waveform
Values between the low limit and the high limit are
shown in green.
Values above the high limit or below the low limit are
shown in red.
v
Low limit value line
This line corresponds to the low limit value. The area
lower than the the low limit value line is gray (page
43).
1-6-2-1. Snapshot
Press the ENT button to stop the waveform screen display in
its current state.
When paused, the cursor appears and the indicator values are
shown in green.
Use the
g
and
t
buttons to move the cursor so you can
check the load at the cursor position.
o
The starting position of the cursor on the horizontal axis is
the “trigger position” (page 54).
o
When paused, holds cannot be started or stopped using
the front panel buttons.
Press the ENT button again to resume the waveform screen
display.
1-7. Static Strain Disp. Mode
Set whether to show the input signal with the strain amount
unit (μst).
Use when checking sensor output and unsteadiness in indica-
tor values, including for sensors and cables, and when making
adjustments for discrepancies.
Press and hold the STRAIN button to exit static strain mode.
NOTE
Static strain is shown using 1-gauge method with a gauge
factor of 2.0.
1-8. Simple indication
Only the indicator value and unit are shown.
