SECTION 14: Error Messages Explained
24
Check the shaft flange
for dirt.
Note 3
3-1) The COLOR and PHOTO ribbon shafts are of
different colors so that the printer can identify the two ribbons.
Since the PHOTO ink/transfer ribbon has a white shaft, you may
see some dirt on its flange depending on the environment.
If that is the case, the printer may identify such a ribbon as
COLOR ribbon by mistaking the dirt for black from a COLOR
ribbon shaft. If the message “ERROR Wrong Ribbon Set” is
displayed when the correct set of PHOTO ink and transfer
ribbons are loaded, check the flange at the protrusion of the
ribbon shaft for dirt.
If you see any dirt on the protrusion, wipe it off.
*Do not use petroleum ether, paint thinner,
alcohol, or other flammable solvents.
3-2) How to mount the disc adapter
1) Set the slide switch on the front of the tray drawer to the RELEASE position.
2) Snap the protrusion of the adapter into the cut-out in the tray, as shown below.
3) Make sure that the adapter firmly sits on the table and then lock the adapter in place by setting the
slide switch to the LOCK position
.
Mounting Disc Adapter-2
Protrusion
Cut-out
Disc adapter
Tray
Mounting Disc Adapter-1
