409-10204
Rev G
17
of 23
2. If the shut height is incorrect, proceed as follows:
a. Remove the two socket head cap screws which secure the ram post adaptor. Remove the ram
post adaptor and shims. Change the shim thickness as required to adjust the shut height. Shims
contain .051- mm [.002-in.] peel-type laminations.
NOTE
If additional shims are required, they can be ordered using the numbers PN 1338618-1.
b. Re-install the ram post adaptor. Insert both screws in the ram post adaptor and place the shims
over the screws and onto the adaptor post.
c. Re-install the socket head cap screws into the ram assembly to secure the ram post adaptor. Re-
tighten the screws.
3. Repeat Steps 1 and 2 as necessary until the proper shut height is attained.
NOTE
The miniature applicator is an integrated assembly consisting of upper tooling, lower tooling, and adjustment capability. The
applicator requires a fixed shut height; that is, the distance between the bottom of the ram and the base mount when the ram
is FULLY bottomed. The required adjustments for crimp height are made by using the wire and insulation discs within the
applicator. Refer to the instruction sheet supplied with the applicator for adjustment procedures.
6.3.
Crimp Height Adjustment Using Precision Adjustment Mechanism
CAUTION
To avoid damaging the applicator, ALWAYS return the precision
adjustment lever to the “0" position when finished using the
applicator.
Figure 12
