409-10204
Rev G
16
of 23
6.1.
Measuring the Shut Height
The shut height is the distance between the bottom surface of the ram post adaptor and the top surface of the
machine base plate as shown in Figure 11.
NOTE
Shut Height Gage PN 679655-2 (see the table in Figure 11) is recommended for measuring shut height (refer to Instruction
Sheet
408-8535
for instructions on use of the gage).
1.
If installed, adjust the manual precision adjustment lever to the “0" setting.
2. Remove the power cord on the end of the motor.
3. Insert a 6-mm hex wrench into the end of the motor until it completely engages the hex key in the end
of the motor. Use the hex wrench to manually rotate the motor.
NOTE
Be sure to remove the hex wrench
and re-install the power cord before operating the machine. The machine will not run
until the power cord is in place.
4. Follow the procedure for measuring the shut height as described in Instruction Sheet
408-8535
.
5. Replace the switch actuator onto the end of the motor.
SHUT HEIGHT GAGE (PN)
MACHINE PART NUMBERS
SHUT HEIGHT DIMENSIONS
APPLICATOR TYPE
679655-2
2161400-[ ]
2161500-[ ]
135.79 mm ±0.025
[5.346 ±.0010 in.]
TE-Type
Figure 11
6.2.
Shut-Height Adjustment
The shut height is pre-set at the factory and should not require further adjustment unless it is necessary to
replace parts. Before you make any changes to the machine, contact your local Field Service Representative,
or call the Support Center at 1-800-522-6752.
CAUTION
NEVER attempt to adjust the shut height without FIRST trying an applicator that is known to produce terminations of the
correct crimp height. If this applicator produces correct terminations, the trouble is in the original applicator and the shut height
MUST NOT BE CHANGED.
If it is determined that the shut height must be adjusted, use the following procedure:
DANGER
T
o avoid personal injury, ALWAYS turn “off" the machine and disconnect th
e power supply to the machine before making any
adjustments. If applicator is an air-feed type, DISCONNECT air lines to valve located on the right side of the machine.
1. Check shut height as described in paragraph 6.1.
Shut Height Dimension
(See Table Below)
