TdA DKC1500 Series, User Manual

Page: 3 / 13

DKC1500 SERIES SLIDING GATE OPERATOR USER
’S MANUAL
3
1.Important safety information
Carefully read and follow all safety precaution and warnings before attempting to install and use
this operator, incorrect installation can lead to severe injury.

The gate operator should be installed by a qualified technician; otherwise, serious personal
injury or property damage may occur.

When opening or closing the gate, do not attempt to walk or drive through the gate.

Children should not be allowed to play near or operate automatic gates.

Keep remote controls away from children, to prevent the gate operator from being activated
involuntarily.

Warning: High voltage in the control box, the control box should be switched off before
repairing it or opening its cover.

The gate operator must be grounded.

Install the gate operator on the inside of the property, DO NOT install it on the outside of the
property where the public has access to it.

Be careful when in close proximity to moving parts where hands or fingers could be
pinched.

It is necessary to install the located blocks on two ends of guide.

Do not allow control devices to be placed so that a person can access them by reaching
through the gate.

In the event of power failure, an emergency release key allows you to operate the gate
manually.

Keep control box away from sunlight and rainwater

Do not change the opening & closing speed arbitrarily.

The operator should be switched off before repairing it or opening its cover.
2. Main features

The device is used to drive the sliding gate and retractable door.

For your safety, the operator will stop if it was obstructed.

Supports up to 40 remote controls.

Infrared terminal (N.C) is supplied to use.

Auto-close feature is available for this operator.

Over-heat protection.

Manual key release design for emergency purposes.
3. Technical parameters
Type
DKC1500 DKC1500Y
Control Control box Integration control board
Power supply
AC240V, 50Hz
Motor power
650W
Motor speed
1400 rpm
Gate moving speed 12m/min(19 teeth); 14m/min (24 teeth)
Output gear
19 teeth (24 teeth, optional)
Output torque
35
N.m
Max. door weight 1800Kg
Reduction ratio
1:30