TdA DKC1500 Series, User Manual, Page: 8 / 13

DKC1500 SERIES SLIDING GATE OPERATOR USER
’S MANUAL
8
1
9
t
e
e
th
:1
2
2
m
m
2
4
t
e
e
th
:1
3
2
m
m
10～15mm
19
t
e
e
t
h
:1
2
2
m
m
24
t
e
e
t
h
:1
3
2
m
m
30
～
35mm
Fig.8
Spring for limit switch
Install the magnet as shown in Fig.9 and Fig.10 below.
To ensure safety, it is recommended to install limit devices at both ends of the gate to prevent
the gate from sliding out of the rails. The rails must be installed horizontally.
Install the plastic block as shown in Fig.7 and a Fig.8. The spring limit switch and blocks are
used to control the position of the gate.
Release the gear clutch with the key and push the sliding gate manually to pre-determine the
position, fix the block to the rack and then tighten the gear clutch with the key. Moving the gate
electrically, adjust the block to the proper position until the position of the opening and closing
meet the requirement.
Rack Left block
Right block
Screw the blocks on rack
Fig.9
Fig.10